04-30-2008, 08:09 AM
|
 |
Administrator
Turbonetics Owners Club Staff
|
|
Join Date: Jun 2006
Location: Socal
Posts: 4,394
|
|
Quote:
|
Originally Posted by David85
Quote:
|
Originally Posted by Robert
The T04B center section would give you options like the Super H, V1/V2, 60-1, etc. Its just a matter of inspecting your back plate and compressor housing to see what fits.
|
OK, so if I understand correctly, the shaft should match.
For the backing plate, I'll need the 4 bolt pattern on the compressor side of the center section, right? Is there anything else I should check if I were to order one?
These are the 60 series turbos that are shown on the turbonetics website:
http://www.turboneticsinc.com/produc...category_id=89
Are these compressors the largest that can be fitted to a T4 center section, or are some of the larger ones compatible as well? (only found a "super T" series on the website) |
A T4 center section could technically take any of the T04 compressor wheels and the 60-1 and 62-1 but it all depends on the backplate and comrpessor housing. The 62-1 is the largest compressor wheel I know of that will fit on a T04B frame.
|