[SOLVED] big shaft help

oldyeller30 · Tweet this Post! #1 (**permalink**) 09-27-2010, 04:02 PM

Need some help. Want to know it the diameters on a ball bearing big shaft are the same as a journal bearing big shaft. If some one has the info on the journal bearing shaft I can compare that to my shaft after measuring my shaft

Thanks in advance guys

Robert · Tweet this Post! #2 (**permalink**) 09-27-2010, 04:28 PM

Quote:

Originally Posted by oldyeller30

Need some help. Want to know it the diameters on a ball bearing big shaft are the same as a journal bearing big shaft. If some one has the info on the journal bearing shaft I can compare that to my shaft after measuring my shaft

Thanks in advance guys

All big shaft units should be 5/16" in diameter

oldyeller30 · Tweet this Post! #3 (**permalink**) 09-27-2010, 04:43 PM

Quote:

Originally Posted by Robert

All big shaft units should be 5/16" in diameter

So then I can put my ball bearing shafts in a journal bearing center section as long as I have it rebalanced right?

Robert · Tweet this Post! #4 (**permalink**) 09-27-2010, 06:49 PM

Quote:

Originally Posted by oldyeller30

So then I can put my ball bearing shafts in a journal bearing center section as long as I have it rebalanced right?

It's not quite that easy but yes technically you could although I don't know of too many places that have a VSR to do the balancing outside of Turbonetics.