[hp80]

Alright I bought a used T3/t04B V-trim compressor wheel with a stage II exhaust wheel in a .48A/R. Its using a Ceramic Ball-bearing cartridge, I beleive. What type of power is this turbo capable of putting out? I am going to put it on my built integra LS bottom end. I am assuming that the top end power on this turbo is not going to be there because of the low A/R? Any help/info you guys could give me would be greatly appreciated. Thank You

Justin

[Robert]

Originally Posted by hp80

Alright I bought a used T3/t04B V-trim compressor wheel with a stage II exhaust wheel in a .48A/R. Its using a Ceramic Ball-bearing cartridge, I beleive. What type of power is this turbo capable of putting out? I am going to put it on my built integra LS bottom end. I am assuming that the top end power on this turbo is not going to be there because of the low A/R? Any help/info you guys could give me would be greatly appreciated. Thank You

Justin

Max Flow on that compresor is about 52 lb/min so it should be good for 400+ WHP depending on the motor etc. The smaller T3 turbine and A/R are probably good for mid 400s MAX. YOu may lose some top end flow with that small an A/R but with only 1.8L of displacement I don't think you'll lose that much. Its actually a pretty decently matched unit for the Honda motors.

[hp80]

thank you for your quick reply Robert You answered what I needed to know. Can't wait to see what she does after tuning.