[BiGZ]

Hello,I am using my evolution wastegate with a turboxs hp dual stage boost controller.My question is how should I route the upper and lower ports on my evolution wastegate to the turboxs ebc? Do I "T" the compressor outlet to both the ebc inlet and the bottom port? Then what do I hook to the evolution top port? Lost on this one,yup!

Thanks In Advance!

[Robert]

Originally Posted by BiGZ

Hello,I am using my evolution wastegate with a turboxs hp dual stage boost controller.My question is how should I route the upper and lower ports on my evolution wastegate to the turboxs ebc? Do I "T" the compressor outlet to both the ebc inlet and the bottom port? Then what do I hook to the evolution top port? Lost on this one,yup!

Thanks In Advance!

Do you have the instructions that came with the Turbo XS controller? I don't typically run MBC units so I'd need to know more about what they recommend before helping. Typically on a EBC you leave the lower port connected to the compressor outlet and add a pressure source only to the top port but again thats a different animal.

[BiGZ]

Hello,thanks for the help here! It's the dual stage model (hooks to a switch for high boost setting) I have the instructions,here's a link
http://www.turboxs.com/faq/turboxsdual.htm
Mine is the model HP DSBC (has the extra ball spring coarse adj)
I undestand how to use with a single port,but unsure about how to hook up to my evolution wastegate properly...
Thanks Again,
BiGZ

[Robert]

Originally Posted by BiGZ

Hello,thanks for the help here! It's the dual stage model (hooks to a switch for high boost setting) I have the instructions,here's a link
http://www.turboxs.com/faq/turboxsdual.htm
Mine is the model HP DSBC (has the extra ball spring coarse adj)
I undestand how to use with a single port,but unsure about how to hook up to my evolution wastegate properly...
Thanks Again,
BiGZ

Well their instructions are referencing an internally gated turbo. From the looks of it you would tee the controller in to the lower port of the Evolution so as to lessen the amount of pressure going to the lower port. This would have the effect of telling the wastegate that it was seeing less boost then it actually is and force it to open later. Keep in mind this is just what I believe to be correct as to truely know TurboXs would need to provide the recommended configuration for an external wastegate like the Evolution.

[Robert]

If it helps at all here's the instructions for hooking up Turbonetics MBC:

http://turboneticsownersclub.com/turbos/mbcinstall.pdf

[BiGZ]

Ok,thanks. (heard back from turboxs this am,was told to leave top port on evolution to atmosphere,and hook bottom as I thought. (between turbo and evolution) Thanks for the help!